2008 HHR – Update #3
Yet another update here, we are closing in on the end of the project, and everything is coming out just as we had planned. We would have this done by now but we are very busy right now with remote car starter installs.
Here you can see the general plan of keeping all the hatch space available while still being able to display everything. The amp is a Memphis MCH600 5 channel amp, this amp delivers 55 watt rms to the 4 interior speaker locations and 400 watts rms at a 1 ohm load for the subs. We chose to keep with the Memphis Music Class line for the subs, using 2 MS104D’s. The sealed enclosure we built for them will allow them to play a variety of music without being to boomy. The entire hatch install will hinge up to allow access to the spare tire and jack. Check back later in the week for another update!
Related posts:
- 2008 HHR – Update #1
We have been very busy at the shop right now with Remote Starter season in full swing, so not much of a first update here....
- 2008 HHR – Update #4
Here you can see the final stages of the trunk install. the first photo shows the plexi glass after being routered for the subs and...
- 2008 HHR – The Final Product!
We are finally here, it’s been a long road to get to this point, with the holiday season, Remote Starter Season and other delays, it...
- 2008 HHR – Retro vehicle, but there’s nothing retro about this install!
When Brodheadsville Chevrolet approached us about outfitting a new HHR with a custom installation and some high end audio gear, we knew we had to...
- 2008 HHR – Memphis Crossover Custom Mounting
This update will start to show some of the custom work for the back. The entire vehicle is wired now, everything in the front of...
