2008 HHR – Update #4
Here you can see the final stages of the trunk install. the first photo shows the plexi glass after being routered for the subs and the Chevy Bowtie logo that Bob hand cut for over the amplifier. The second photo shows the basic trim panel before being finished. Finally the third photo shows the steel angle bracing that we used to support all the weight of the enclosure/amp rack. this was necessary for the hinging. The same photo also shows that we have now removed the factory option panel on the driver’s side and inserted a piece of painted acrylic (future pics will show more detail) that will be edge lit for our logo.
We are making every effort with our overbooked schedule to get this vehicle done soon, hopefully the next update will be the final one!
Related posts:
- 2008 HHR – Update #1
We have been very busy at the shop right now with Remote Starter season in full swing, so not much of a first update here....
- 2008 HHR – The Final Product!
We are finally here, it’s been a long road to get to this point, with the holiday season, Remote Starter Season and other delays, it...
- 2008 HHR – Update #3
Yet another update here, we are closing in on the end of the project, and everything is coming out just as we had planned. We...
- 2008 HHR – Memphis Crossover Custom Mounting
This update will start to show some of the custom work for the back. The entire vehicle is wired now, everything in the front of...
- 2008 HHR – Retro vehicle, but there’s nothing retro about this install!
When Brodheadsville Chevrolet approached us about outfitting a new HHR with a custom installation and some high end audio gear, we knew we had to...
